85180, PeakFilter

Multiplex, 85180, peak filter

Peak filter Multiplex 85180 A simple, effective accessory to increase the safety of the receiving system /
Power in Modell.I nsbesondere on the operation of battery switching
Diodes base * and use of high performance servos there is the risk that
by energy recovery ( "dynamo effect") of the servos in the power supply dangerous
high voltage peaks occur. This can not be the receiver battery
are buffered if the batteries of the servo / receiver side by the locking action
the diodes are blocked.
The spikes can be far above the permissible operating voltage of the receiver
lie and the " exit" of the microcontroller or even damage to the
Receiver lead since they u.U. by integrated in the receiver not measures
can be sufficiently buffered.
The peak filter is simply connected to a free receiver output and
effectively suppresses dangerous voltage spikes. Even temporary voltage dips
be bridged. Thus, the peak filter is in any case a useful extension,
which increases safety in the receiving system, whether with or without
Battery switch. Quantity: 1 piece with mounting material

* The MULTIPLEX receiver with integrated
Battery switch (RX 12 DS IPD, RX-9/12-SYNTH DS IPD) are equipped with a diode battery switch, when this effect
can occur in principle.

However, these and all other MULTIPLEX receivers are checked for this influence back.
Regarding Overvoltage protection by inducing voltage peaks of the servos ( "dynamo effect")
could by sufficient safeguards for our recipients no influence
be found. Nevertheless, the use of the peak filter for security makes sense and
recommended.

Technical specifications:

- Dimensions (Ø x L) ca. Ø 18 x 36 mm

- Weight 15 g