Zepsus Magnetic Switch 7A F3J-F3B-F3F

Zepsus Magnetic Switch 7A F3J-F3B-F3F

Designed for F3F and F3B model gliders.
Very small and very strong.

Introduction
This is a very small power switch designed for F3F and F3B remote controlled model gliders. With this switch your RC model can be turned on or off without your need to access it internally. Just move a magnet over the switch, on the outside of the model, and it turns on. To turn it off just pass the magnet by the switch again. The switch has an ultra low power consumption in off-state. The consumption is so low that the switch can be connected to a 300mAh battery for several years without discharging it. The switch has a built-in failsafe function. It remembers its state for at least 10 sec, if disconnect from the battery. It will protects the switch against power glitch caused by bad battery connection etc.

Technical Data:
- Input voltage range: 3v"13v
- Ultra low dropout voltage: 40mV@11A
- Output current constant: 7A
- Output current burst: >20A
- Ultra low stand-by current: 5µA (micro- ampere)
- Connectors: JR-type
- Wire: high-quality 0.5mm2 / AWG 20
- Weight including cables: 4.3 grams / 0.15oz.
- Length including cables: 18 cm / 7 in
- Dimensions: 25 x 8 x 5 mm / 0.98 x 0.31 x 0.20 in
- Operational temperature range: -40C to +50C

Production test
All switches have been tested with 10A for 30 sec before delivery. Standby consumption is controlled and a visual inspection is made.