GRAUPNER Switch module 10A S8527

GRAUPNER Switch module 10A S8527

Artikel-Nr: GS8527
EAN: 8809403498047

With the 10 A switching module, it is possible to switch a load directly via a receiver output. The receiver output must be programmed for level control (ON/OFF) (from receiver software version V7.XX).
An encoder (toggle switch) can be assigned to the switching channel (mc-16 to mc-28 or mx-12 to mx-20, mz-18 and mz-24)
With themz-32 and mc-32 (version 2019), digital switches on the touchscreen can also be programmed as encoders. Both ON/OFF and BLINKEND
The jumper is used to differentiate between power supply to the load via receiver (jumper set) or external supply. (jumper removed) With external power supply via X3/X4, the jumper MUST be removed, otherwise the receiver, the components connected to the receiver and the switching module will be damaged!
The load (motor, LED, light bulb etc.) is connected to X1 / X2. No cables are soldered to the circuit board, so it is possible to use different cable thicknesses and connector types.

The module can either be attached to the model using double-sided adhesive tape or cable ties. When mounting, make sure that the circuit board is not bent and that the underside of the circuit board does not touch any other components (risk of short circuit).
After soldering the cables to X1-X4, the enclosed shrink tubing is pushed over the circuit board and shrunk with a hot air gun. Different cable lengths and thicknesses can be used for X1-X4, depending on where the consumer is located.

Features:
- Operating voltage 4.0 - 8.4V via receiver
- Switching current max. 10 A
- Switching voltage max. 20 V
- Dimensions 23 x 11 x 5 mm
- Weight < 2g
- Required control channels 1x encoder or digital switch