Robbe 2645 K-RAT II PNP WITH RO-POWER TORQUE DRIVE AND SERVOS
"K-RAT II" is a modern all-round model based on the legendary "ur" K-RAT from 1997 by ROBBE. The new model II meets the most modern requirements in terms of construction and aerodynamic design. The model is suitable for fast flights, aerobatics and feels just as comfortable in the thermals (thanks to controlled rudder) as well as a fun and training model. Due to the balanced and good-natured flight characteristics, even those switching from 2-axis to 3-axis models will find the perfect model. Not only the less experienced, but also the ambitious model pilot gets an all-round model for almost any weather and application. The model has some outstanding detailed solutions such as its own servo shaft on the underside of the fuselage for elevator and rudder servo, wing panels that can be attached laterally via a CFRP round rod, wing locking with "CLIP fixing" and a very high degree of prefabrication as only the required battery including controller and receiver need be installed.
TECHNICAL SPECIFICATIONS:
- Wingspan: 2000 mm
- Weight: ca.1500g (flight)
- Recommended engine: Ro-Power 3522/1000
- Control: H, S, Q, M
- Manufacturer: Robbe
- Fuselage: GRP / CFRP
- Surfaces: wood / ribbed, fully paneled
- Version: PNP - PLUG N PLAY
- Recommended battery: 4S / 2600mAh LiXX
- Drive type: electric
The product K-RAT II PNP WITH RO-POWER TORQUE by ROBBE in the category electric glider has a wingspan of 2000 mm and a weight of ca.1500g (avg.). The model is controlled via the functions H, S, Q, M. The model is designed as a PNP - PLUG N PLAY and is suitable for advanced users. The completion of the model is easy for beginners without previous knowledge. We recommend a 4S / 2600mAh LiXX battery for this electric flight model.
Scope of delivery:
- Model PNP with GFK / CFK fuselage and fully covered wing halves as well as tail units in solid wood construction (balsa planked rib construction)
- Ro-Power Torque 3522/1000 motor installed
- 4x FS 155 BB + MG servos installed
- Pendulum elevator
- CFRP surface connector
- Wing securing by "clip fixing"
- Small material for steering control
- Aluminum spinner with offset and propeller 11x8 "
- Oracover covered
- Extensive assembly instructions in German, English and French