Not available any more!!! archive items YGE ESC 90-120 LV K (V3)

YGE 120A Brushless ESC - Controller 2-6S with heat sink (V3)

Item number: YGE120LVK
EAN: 8595241394572

The next generation of YGE brushless controllers with many new features:
i.a.
- Governor mode
- Governor-Store-Mode
- Soft start with selectable acceleration speed
- Active freewheeling
- Autotiming
- Infinitely adjustable F3A brake (acro brake)
- Many parameter settings with the new ProgCard III (including the special feature of precisely programming the cut-off voltage of LiFePo cells)

Governor mode:
- is the classic heli mode. Here the target speed is set on the transmitter. The governor takes care of the rest.

Governor-Store-Mode:
- Has the same effect as governor mode. In addition, the speed achieved during the first flight is stored in the controller,
- so that the same speed is reached again in the next flight with a different battery (slightly different voltage level or half full battery).

Active freewheel:
- This is an optimisation that makes the YGE brushless controller absolutely resistant to partial loads, thus reducing unwanted heating to a minimum.

Stepless F3A brake
- The F3A brake ensures a constant speed in descent manoeuvres for aerobatic and acro models.

Of course, this new software includes the familiar functions for electric gliders and powered models.

NEW, with mode programming via the transmitter for:
- V-Stabi-Governor
- Governor
- Governor Store
- Motorised glider with brake
- Powered flight without brake

Technical data:
- 120A max. continuous full throttle current with good cooling.
- 3 to 6s LiPo, reverse control in the event of undervoltage.
- Undervoltage detection can be switched off.
- Pulsed BEC: 5.7V / 7.4V / 8V adjustable via jumper, 8A continuous, 18A peak.
- 2 BEC cables (master and slave) Observe the notes on the BEC in the instructions
- Speed control (governor mode).
- Speed signal output (V-Stabi Governor).
- Soft start.
- Active freewheeling, therefore unlimited partial load resistance.
- Automatic timing, or adjustable in 6 steps.
- Infinitely adjustable F3A brake.
- Normal EMF brake adjustable in 3 stages.
- Cycle frequency: 8 to 16 kHz
- Speed limit: 240,000 rpm (2-Poler)
- Overtemperature / overload warning
- Anti-flash circuit: Reduces the switch-on spark
- Dimensions: 72 x 32 x 19 mm
- Weight: 68g, with cable 98g
- Programming via mode setup or with the ProgCard II or III

Scope of delivery:
- 1 YGE 120A brushless speed controller with instruction manual