JETI Duplex 2.4EX Central Box 400 80001604

JETI Duplex 2.4EX Central Box 400 80001604

Artikel-Nr: HA80001604
EAN: 8595245909994

Product description and features
The CentralBox 400 is a combination of a heavy-duty battery backer with adjustable voltage reduction, 24 programmable and fused servo connections and up to 4 telemetry connections. Up to 2 receivers or satellites with serial (JETI EX-Bus) or PPM sum signal can be connected. Commissioning is carried out with a coded magnetic switch, which prevents unwanted switching off due to vibrations or switch failure. Optionally, the Central Box 400 can also be switched ON/OFF via the RC switch of the JETI Duplex DS/DC transmitter (RC switch not included).

Configuration via JETI Duplex DS/DC transmitter
The full potential of the Central Box 400 can be utilised with JETI Duplex DC/DS transmitters. The entire configuration of the servo outputs, DITEX servo and JETI EX telemetry, function assignment etc. can be carried out very easily via the device overview of the JETI Duplex DS/DC transmitter.

Compatibility with Futaba S.Bus
The Central Box 400 can also be used with two S.Bus receivers (e.g. Futaba R7003SB). However, settings and reading out the telemetry values must be carried out via a separately available JETIBOX.

Switching on and off
The Central Box 400 is switched on and off using the magnetic switch supplied.

Recommended receivers
For example, 2 RSat2 or REX3 receivers can be used as receivers. Optionally, a REX Assist receiver can be used together with an RSat2 receiver to create a central box with gyro stabilisation.

Properties
- Adjustable high-performance BEC for voltage stabilisation (connection of standard or HV servos)
- DITEX servo telemetry support
- Possibility to connect up to 3 receivers with serial communication
- Built-in expander function with the option of independent connection of up to four JETI EX sensors
- Input for magnetic switch or RC switch
- Power supply batteries connected via MPX connector
- 100Hz mode of the servo outputs (10ms period)
- EX telemetry support (measurement of voltage, current, capacity, temperature, etc.)
- Simple setting changes via DC/DS transmitter (‘Device Explorer’)
- Robust metal construction with mounting holes

Technical data:
- Servo outputs: 24
- Receiver inputs: up to 3
- Satellite receiver support: Yes
- Telemetry: Yes
- DITEX servo telemetry: Yes
- Battery inputs: 2
- Supply voltage [V]: 6,0 bis 14,0
- Voltage regulator [V]: 5,0 bis 8,4
- Permanent current [A]: 30
- Peak current (ca. 300ms) [A]: 200
- Current consumption in OFF state [µA]: 60
- Operating temperature [°C]: -20 to 75
- Dimensions [mm]: 86 x 130 x 19
- Weight [g]: 271

Scope of delivery
- 1 JETI Duplex 2.4EX Central Box 400
- 1 magnetic switch
- 1 magnetic key
- 1 patch cable

Important note
If the Cortex pro is operated on a CentralBox, please be sure to use an additional patch cable for the +/- supply. See the detailed bavarianDEMON CORTEXpro Manual.

Do not connect any third-party sensors to EXT4! Some third-party sensors put the CB400 into programming mode when switched on! As a result, there is a risk that the sensors will ‘reprogramme’ the CB400 and the model can no longer be flown!