Brushless speed sensor for UniTest 2, UniLog 1 + 2

Brushless speed sensor for UniTest 2, UniLog 1 + 2

Item number: 2213
EAN:

Brushless speed sensor for UniTest 2, UniLog and JLog2. Is simply connected to a supply line of the brushless motor to measure the speed.
In the setup of the UniLog / UniTest 2 / JLog 2 the correct number of measuring pulses per revolution must be set for the speed measurement. For the optical and magnetic sensor this is the number of propeller blades or magnets. For the brushless speed sensor, this is the number of motor poles. A classic internal rotor such as a Lehner or Hacker motor has 2 poles. An external rotor usually has 10 or 14 poles.
In addition, the gear factor can also be specified. If the speed of an internal rotor with gearbox is measured with the brushless speed sensor, an attached gearbox can also be included. This gives the actual propeller speed.

Technical data:
- Cable length: 300 mm

Scope of delivery:
- brushless speed sensor single
- Plug connector for connection to the motor cable