13313 Discus 2c 18m Wingspan. 1020mm

Graupner 13313 Discus 2c 18M Wingspann 10210mm

The Discus 2c 18 m was made from original data with the support of Schempp Hirth, except for the change for the Vector Unit section and the adjustment of the wing to tailplane adjustment angle, all this is the 100 percent reduction of the 3-side view. The imprint on this model was created from original images of the aircraft, even the cockpit area with pilot is 1: 1 from the original. The spar reinforcements are made from the Spaltabdeckband the man-carrying aircraft. The model is made of Vector Board and is printed, cut and packed here in Germany.

Fun for the evening at the airfield


If you are several pilots, you can also have a small OLC competition. Represents two turnflags no. 168522 at a distance of 50 m, that's the course you have to fly.
1.) Choose the throttle setting so that the model with its fully charged battery just holds the height and can control it well.
2.) On the trigger switch of the mz-4 remote control you have full throttle, if you use the trigger switch, must be circled, so thermals fly.
3.) Release trigger switch, then go back on track
4.) The one who made the most laps wins.
That's fun.

Use the Vector Unit from other models, such as Emma or Leo, replace the propeller with the propeller with the A so that the propeller points forward and blows backwards then it can start.

Flying and flight characteristics:

The model has very good flight characteristics.
The position of the Vector Unit is chosen so that the model can be controlled easily and easily.

The focus:

Is set so that the model with about full throttle reserves the nose up and rises slightly. If you take out the gas, the model airplane goes into a slight curve and slides to the ground.

Tuning:

For more power you can tune the Vector Unit with the Extreme Motor No.34001.4 and the new 220 mAh battery No.78102.1 and use the same propeller as before.

Assembly:
Assembly is limited to attaching the Vector Unit using tape strips (both not included in the kit) applying the self-adhesive rail reinforcement (please refer to the video instructions), inserting the wings, attaching the elevator to the fuselage.

The model Dicus 2c 18m:
- Great prototypical flight image
- Scale look through photo printing
- Very robust by Vector Boards
- Quick assembly without glue

Kit contents:
1x hull, 8 mm Vector Board
1x wing, 3 mm Vector Board
1x horizontal stabilizer, 3 mm Vector Board
2x bar reinforcement 700x6x0.35mm

Required accessories
- No. 34002 Vector Unit
- No. S1031 mz-4 HoTT

Technical specifications:
- Height [mm]: 80 mm
- Weight [g]: 34 g
- Length [mm]: 400 mm
- Span [mm]: 1020 mm