Avatar F3B E-fuselage IDS-KST and with protectionbags Version 2

Avatar F3B Electro

LDS allready build in for KST

The model is manufactured by Jiri Tuma. Jiri created a special technology to make wings stiff and light enough for this thin airfoil. Also special is the space between fuselage and wing and V-tail as shown on the pictures . This will help to reduce interferences and drag. The model is built in double-carbon with carbon V-tail. Fuselage same as EXTASY in carbon and nose-cone 2,4 Ghz ready (Kevlar- Glas). There are 5-ballast tubes (3 in the joiner and 2 in the wing) which allows 1800g only with use of brass! No expensive wolfram needed ! Gunther flew this model 3 weeks after maidenflight on the last contest of the season on the „Oktoberfestpokal" in munich and won the senior award.

Technical Data:

- Category: F3B-E
- Concept: Two part wing, two part elevator, v-tail
- Wing span: 3150 mm
- Length: 1490 mm
- Wing area: 55 dm2
- V-tail angle: " 100°
- V-tail area: 5,10 dm2
- Wing airfoil: Dirk Pflug Avatar
- Elevator airfoil: Dirk Pflug Avatar
- Weight: from 2050g
- Ballast: 1800g
- Maximum servo width: wing center: 10 mm (Futaba S3150 or Graupner DS 3288) , wing tip: 10 mm (Futaba S3150), fuselage: 12 mm (Graupner 3871)

Construction:
- Wing carbon-carbon
- Spar HT Carbon
- Tailplane carbon-glass
- Fuselage carbon-glass-kevlar

Scope of delivery:
- Model Avatar- electro
- Protection bag
- LDS system with servo frames, etc. Suitable for KST allraedy build in