offset 0° clamp middle part 38/8mm-6mm

offset 0° clamp middle part 38/8mm-6mm

REISENAUER offset 0° clamp-middle piece
38/8mm - shaft 6mm incl. screws

More perfect lying of most of the prop blades on the hull.
Suitable for REISENAUER spinner caps.

38mm Clamp-middle piece offset 0° fits depending on prop-bend, width,
slope and hull shape on the caps with diameter 40 - 45 mm.

Precise guidance from Prop-gum (size S) with proven circumferential clamping of the shaft.

To adjust to the prop:
The cap cutouts slightly increase (approximately up to 4-6mm - mostly only necessary on one side).

If used instead "Dremel", knife or e.g. Polycarbonate shears, please cap heated beforehand to avoid bursting.

On picture: ASW 24 with 20x13 GM CFK with 44 SCALE cap