FUTABA Servo S3270SV (3,0kg 0,11s/60°) F1821

FUTABA Servo S3270SV (3.0kg 0.11s/60°)

Item no.: F-S3270SV
EAN: 4513886025839

The S3270SV is an HV S.BUS2 servo which, in addition to metal gears and an aluminium housing centre section, also has an enormous torque of 30 Ncm. The servo is very fast at 0.08 sec/45°. The motor setup was selected so that LV operation (5.7...6V BEC) with sufficient power and speed is just as possible as HV operation directly on 2S LiPo batteries. Areas of application are: wing servo for gliders, elevator servo for medium and large gliders. Elevator servo for F3A machines. Swashplate servo for 450 class helicopters, etc.

Programmable thanks to S.BUS technology! Of course, all S.BUS2 servos can be connected to conventional receivers with PWM modulation. The servos can be addressed in various ways:

1. via the S.BUS receiver
2. with the handy SBC-1 programmer
3. via the PC-Link software with the CIU-2 USB adapter
4. on the S.BUS connection of the transmitter

The following parameters can be set:
- S.BUS channel assignment
- Servo polarity
- Servo type (normal / retractable landing gear)
- Soft start (on / off)
- Mode selection for signal failure Hold or Free
- Soft servo run (On / Off)
- Servo position (servo tester)
- Servo centre adjustment +/- 300 µs (approx. 30 degrees)
- Servo speed, 0.39...9 seconds per 45 degrees
- Deadband setting (dead band)
- Servo travel adjustment left and right separately, approx. 50...175%
- Starting power
- Damping
- Holding force
- ID memory

Technical specifications
- Operating voltage: 6.0 - 7.4 V
- Actuating speed 60° (7.4 / 6.6 V): 0.09 / 0.11 s
- Actuating torque (7.4 / 6.6 V): 3.0 / 2.6 kgcm
- Control frequency: 50...300 Hz
- Dimensions: 23x11.8x28.8 mm
- Weight: 16.2 g

Features
- Powerful S.BUS2 digital servo with metal gears
- Hi-Voltage
- Ball bearings
- Robust aluminium-plastic housing
- High resolution
- High return accuracy
- Low-wear potentiometer
- Water-protected

- Operating voltage: 6.0 - 7.4 V
- Actuating speed 60° (7.4 / 6.6 V): 0.09 / 0.11 s
- Actuating torque (7.4 / 6.6 V): 3.0 / 2.6 kgcm
- Control frequency: 50...300 Hz
- Dimensions: 23x11.8x28.8 mm
- Weight: 16.2 g