Servo FUTABA S3172SV MG BB S.BUS2

Futaba, F1631, Servo-S3172SV HV S.BUS2

Art.-Nr.: 01000917, P-S3172SV
EAN: 4513886024412

HV S.BUS variant of the proven S3150 digital servos. With the tremendous torque of 45 Ncm only 10.8 mm 'thickness'.

This rugged surface servo has a 5-speed transmission with 4 metal gears, with 2 ball bearings, the output gear excellently supported against centrifugal forces. Wide voltage range of 6 .. 7.4 volts. Ideal as a space power, even for large sailing and competition machines, as well as mini and micro helicopters. S.BUS2 with standard, but can also be operated at normal receivers.
Programmable!
Of course, all S.BUS servos connected to receiver with conventional PWM modulation.

Addressing the servos can be done in several ways:
First About the S.BUS receiver
Second With the handy programmer SBC-1 no. F1696
Third About the S-Link software, this USB adapter CIU-2, no. F1405 required.
4th On S.BUS connect the transmitter T18MZ

In addition, all S.BUS servos are programmable.
The following functions can be set:
- S.BUS channel assignment
- Servo reverse
- Servo type, normal - Retracts
- Soft start-up, on-off
- Mode selection of signal failure or Free Hold
- Soft Servo drive, on-off
- Servo position (servo tester)
- Servo center adjustment + / - 300 iS (about 30 degrees)
- Servo speed, 0.39 ... 9 seconds per 45 degrees
- Dead band setting
- Travel adjustment separated left and right, about 50 .. 175%
- Starting Power
- damping
- Holding force
- ID storage