14011 Servo Hawk 4,8-8,4V 25x8,5x34,5

Graupner 14011 Servo Hawk 4,8-8,4V 25x8,5x34,5mm

Thin wings? No probelm!

The Hawk Servo is an 8 mm servo with full aluminum housing and metal gear for the highest demands when it comes close. The servo has both very good torque and power, so as a high speed at these values.

The servo connection cable has a length of 50 mm and is ideal for installation in wings without having to cut the cables or have cable clutter in the wing.

The housing and the output gear (25T) are adapted to today's standard dimensions. The servo is perfect as a wing servo.

The servo arm is screwed with an M2
hexagon socket screw.

Included in the set:
- 1 x Servo
- 1 x Hardware pack
- 1 x Aluminum servo arm
- 1 x High quality "Controlled by the wild" sticker

Specification:
- Torque at 4.8 V, approx. [Ncm]: 13 Ncm
- Width [mm]: 8.5 mm
- No-load current drain: 13 mA
- Transit speed at 4.8 V, approx. [Sek / 40°] : 0.12 Sek/40°
- Holding torque 6.0V, approx. [Ncm]: 60 Ncm
- Charging rate at 4.8 V approx. [mA]: 1000 mA
- Height [mm]: 34.5 mm
- Transit speed at 6.0 V, approx. [Sek / 40°] : 0.10 Sek/40°
- Weight [g]: 22 g
- Transit speed at 7.4 V, approx. [Sek / 40°]: 0.08 Sek/40°
- No-load current drain, approx. [mA] : 13 mA
- Torque at 6.0 V, approx. [Ncm]: 16 Ncm
- Holding torque 7.4V, approx. [Ncm]: 66 Ncm
- Overall length [mm]: 25 mm
- Charging rate at 6.0V approx. [mA]: 1200 mA
- Dimensions [LxWxH in mm]: 25 x 8.5 x 34.5 mm
- Holding torque 4.8V, approx. [Ncm]: 48 Ncm
- Torque at 7.4 V, approx. [Ncm] : 20 Ncm
- Bearings: 2 Ball-Bearing
- Charging rate of 7.4 V approx. [mA]: 1500 mA
- Gear unit: Both mg
- Operating voltage neutral [V] : 4...8.4 V
- Neutral impulse: 1.5 ms
- Max. operating frequency [ms / Hz]: 330 ms / Hz
- Field of application: Aircraft
- Coreless: +
- Length [in]: 0.98 in
- Torque at 6.0V, approx. [kg.cm] : 1.6 kg.cm
- Torque at 7.4 V, approx. [kg.cm] : 2 kg.cm
- High [in]: 1.35 in
- Width [in]: 0.31 in