138114, Servo HSR-1425 CR ROBOT-Servo

Hitec, 138114, Servo HSR-1425 CR ROBOT-Servo

Introducing the all new HSR-1425CR Continuous Rotation servo. If you are looking for a servo to pan or tilt your small camera or sensor multiple turns, this is the servo you need. If you are looking for a servo to power the wheels on your small robot, this is the servo you need. Fully proportional speed forward and reverse for precise movements. The potentiometer has been taken out and the dead-band increased to eliminate "creep" that occurs in many other servos that are modified for continuous rotation. Dual ball bearings on the output shaft ensure long lasting performance. Note: This servo does not have position feedback.

Detailed Specifications:
- Control System: +Pulse Width Control 1500usec Neutral
- Required Pulse: 3-5 Volt Peak to Peak Square Wave
- Operating Voltage Range: 4.8-6.0 Volts
- Operating Temperature Range: -20 to +60 Degree C (-4F to +140F)
- Operating Speed (4.8V): 44 RPM at no load
- Operating Speed (6.0V): 52 RPM at no load
- Operating Torque (4.8V): 38.8 oz-in (2.8 kg-cm)
- Operating Torque (6.0V): 42 oz-in (3.1 kg-cm)
- Continuous Rotation Modifiable: Completed (Stock)
- Direction: Clockwise/Pulse Traveling 1500 to 1900usec
- Idle Current Drain (4.8V): 3mA at stop
- Idle Current Drain (6.0V): 3mA at stop
- Motor Type: Brushed
- Potentiometer Drive: No Potentiometer
- Bearing Type: Dual Ball Bearing MR106
- Gear Type: Nylon Gears
- Connector Wire Length: 7" (178mm)
- Dimensions: 1.59" x 0.77"x 1.44" (40.6 x 19.8 x 36.6mm)
- Weight: 1.47oz (41.7g)